u-boot_board_info [Doku Wiki]

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
===== Overview =====

Explanation of initialization of ''struct bd_info'', in the context of Zedboard.

===== include/asm-generic/u-boot.h =====

Non-Zedboard content removed for brevity.

<code>
typedef struct bd_info {
        unsigned long   bi_memstart;    /* start of DRAM memory */
        phys_size_t     bi_memsize;     /* size  of DRAM memory in bytes */
        unsigned long   bi_flashstart;  /* start of FLASH memory */
        unsigned long   bi_flashsize;   /* size  of FLASH memory */
        unsigned long   bi_flashoffset; /* reserved area for startup monitor */
        unsigned long   bi_sramstart;   /* start of SRAM memory */
        unsigned long   bi_sramsize;    /* size  of SRAM memory */
#ifdef CONFIG_ARM
        unsigned long   bi_arm_freq; /* arm frequency */
        unsigned long   bi_dsp_freq; /* dsp core frequency */
        unsigned long   bi_ddr_freq; /* ddr frequency */
#endif
...
        unsigned long   bi_bootflags;   /* boot / reboot flag (Unused) */
        unsigned long   bi_ip_addr;     /* IP Address */
        unsigned char   bi_enetaddr[6]; /* OLD: see README.enetaddr */
        unsigned short  bi_ethspeed;    /* Ethernet speed in Mbps */
        unsigned long   bi_intfreq;     /* Internal Freq, in MHz */
        unsigned long   bi_busfreq;     /* Bus Freq, in MHz */
...
        ulong           bi_arch_number; /* unique id for this board */
        ulong           bi_boot_params; /* where this board expects params */
#ifdef CONFIG_NR_DRAM_BANKS
        struct {                        /* RAM configuration */
                phys_addr_t start;
                phys_size_t size;
        } bi_dram[CONFIG_NR_DRAM_BANKS];
#endif /* CONFIG_NR_DRAM_BANKS */
} bd_t;
</code>

===== board_f.c [init_fnc_t] =====

==== reserve_board() ====

<code>
/* (permanently) allocate a Board Info struct */
static int reserve_board(void)
{
        if (!gd->bd) {
                gd->start_addr_sp -= sizeof(bd_t);
                gd->bd = (bd_t *)map_sysmem(gd->start_addr_sp, sizeof(bd_t));
                memset(gd->bd, '\0', sizeof(bd_t));
                debug("Reserving %zu Bytes for Board Info at: %08lx\n",
                      sizeof(bd_t), gd->start_addr_sp);
        }
        return 0;
}
</code>

==== setup_machine() ====

Not set for Zedboard.

<code>
static int setup_machine(void)
{
#ifdef CONFIG_MACH_TYPE
        gd->bd->bi_arch_number = CONFIG_MACH_TYPE; /* board id for Linux */
#endif
        return 0;
}
</code>

==== dram_init_banksize() [board/xilinx/zynq/board.c] ====

<code>

</code>